Flexible Optical B.V. (OKO Technologies)
 
  • Home
  • FAQ
  • Wavefront sensors
  • How to use FrontSurfer wavefront sensor for optical shop testing?
  • Home
  • News
  • Catalogue
  • Publications
  • Technical documents
  • FAQs
  • Search
  • Contact us
banner_1.jpg

How to use FrontSurfer wavefront sensor for optical shop testing?

Setup for testing of optical components should provide optical conjugation between the component under test and the wavefront sensor with proper scaling. See section our Product Guide for general recommendations and typical measurement schemes.

  • AO systems
  • Wavefront correctors
  • Wavefront sensors
  • Software
  • Electronics
  • Consulting
  • Technical articles
  • Contact form

Top news

  • 79-ch 15 mm MMDM with optimised actuator geometry
  • Technical support in China
  • Welcome to Flexible Optical B.V.
  • MADEin4
  • Simulation of OKO DMs in Zemax

Top FAQs

  • What driver is faster -- PCI board or USB unit?
  • How to use FrontSurfer wavefront sensor for optical shop testing?
  • What is "biased operation"?
  • How good is the initial figure of OKO deformable mirrors?
  • What is the closed-loop correction speed in FrontSurfer?

Polakweg 10-11, 2288 GG  Rijswijk, the Netherlands • Tel: +31 70 262 94-20 • This email address is being protected from spambots. You need JavaScript enabled to view it.

Copyright  ©  Flexible Optical B.V.   2022